Hardware
Hi guys im modding my nintendo switch OLED for the first time. soldered everything but the first error i got is
==* CPU always reach BCT check (no glitch reaction, checkmosfet)
i pretty confident with my soldering skill
This is the picture of the mosfet soldering
After changing my to new mosfet. the error still persist and i spray they board with pcb cleaner multiple times.. resolder some broken link because of the thin wire.. slight movement might cause it to break.
i got into this error.
CMD not connected. after further inspection i guess the cmd resistor was broken. i replaced it to another resistor which is bigger in size but same value.. i also soldered 0.02mm to connect the connection but the error still persist.
Do you guess think my wire is too thin ? is there anyone sucessfull modded the switch using my 0.02mm.
Please advice i dont know what to do anymore.
Please also advice what is the value of diode mode for each pin.
Value of diode mode of before the point is connected to picofly
Dat0 = 0.774v
CLK = 0.785v
this is my value after installed all point on diode mode
RST 1.259v
CLK 0.783v
CMD 0.774v
DAT0 0.781v
PWR 0.838v
GND 0v
is there any abnormalities here ?
If some one please share with me there working value of the diode and also the voltage value when its turning on. this also might help greatly for me to pinpoint which part is bad.
This is my kamikaze dat0 picture, maybe i did mistake here
==* CPU always reach BCT check (no glitch reaction, checkmosfet)
i pretty confident with my soldering skill
This is the picture of the mosfet soldering
After changing my to new mosfet. the error still persist and i spray they board with pcb cleaner multiple times.. resolder some broken link because of the thin wire.. slight movement might cause it to break.
i got into this error.
CMD not connected. after further inspection i guess the cmd resistor was broken. i replaced it to another resistor which is bigger in size but same value.. i also soldered 0.02mm to connect the connection but the error still persist.
Do you guess think my wire is too thin ? is there anyone sucessfull modded the switch using my 0.02mm.
Please advice i dont know what to do anymore.
Please also advice what is the value of diode mode for each pin.
Value of diode mode of before the point is connected to picofly
Dat0 = 0.774v
CLK = 0.785v
this is my value after installed all point on diode mode
RST 1.259v
CLK 0.783v
CMD 0.774v
DAT0 0.781v
PWR 0.838v
GND 0v
is there any abnormalities here ?
If some one please share with me there working value of the diode and also the voltage value when its turning on. this also might help greatly for me to pinpoint which part is bad.
This is my kamikaze dat0 picture, maybe i did mistake here
Last edited by Pait,